2017 Ski Doo Renegade X shaper bar install

Dan Kresan
Dan Kresan
1,349
0
Published 2017-09-24
The factory carbides weren't what I felt they should so I'm installing a set of Studboy shapers. Didn't show the rubber mallet used. The dogs did stop barking after I was done.
All Comments (6)
  • @alpinweiss
    I would really consider changing these skis to something else. Just try Blades from Brp or PowderPro. I bet you'll love em
  • @shperax
    wow I have plastic kimpex ski's that still look brand new after 5 years. You must be pretty hard on that sled. I also Run Shaper Bars. Work fantastic.
  • @johneel7766
    Ive never taken skis off to change carbides...
  • @jmj267
    I just ordered another set and got it yesterday and I'm going to install them hun the inboard because my sled is up north and I didn't know I had to buy two packages. So last year I ran with my inboard one stock and the outboard one shape or bar it tilted to ski in and it was crappy 2 turn. So when I go up next week and I will install the new bars on the inboard. This is on a 2015 Grand Touring SE Ski-Doo with no studs I did go with 6 in carbides. How does your slide right now? And did you do the same and put another set on to make two full sets?