Tutorial / How to Make a Bubble Wall - Tutoriel / Comment faire un Mur de Bulles

Namsan LED
Namsan LED
2,204,358
0
Published 2012-10-29
Tutorial how to make a bubble wall
Tutoriel comment faire un mur de bulles
Open to see more below !
Check my other videos :    / @namsanled  

- Plexiglas alltop 2000x980x64x16mm
- LED Strip RGB SMD multicolor with remote
- Air pump 470 mbar
- Alu frame white
- Wooden box white
- Music : Fev.r (Adam Fr.eland R.mix)
All Comments (21)
  • @erwin280
    I made this 5 years ago. It was almost done but i was struggeling with the pumps and bubbles. The aquarium pumps weren't strong enough to withstand the water pressure so i bought a piston pump for it. After that was okay i couln't get the bubbles the same amount in each shaft. After a couple of minutes the outer two were losing pressure so maybe just not enough power. I didn't use a tube with holes but covered the bodem of the plate and made a nipple in each shaft and connected it to a rail that is connected to the pump. After this i made an adjustible air valve after each nipple to regulate the amount of air to every shaft. After a couple of tweaks it worked well but the valves were bad quality because they were leaking water. Shortly after this i was forced to move to a other appartment and had no room for it and stored it away. But within 2 months i'm again moving to another (bigger) appartment and i already have plans to finish it.
  • @NamsanLED
    Thanks, yes one hole per compartment but you can use two if you want.
  • @BayareaJay
    OOOoooh......so that's how you make it! LOL!!!
  • @pixildot
    such a amazing tutorial vdo, i learn a lot
  • @wickedgrafix
    Did I really just watch a 2 1/2min video of photos! Great clear photos I guess!!
  • @JohnSmith-nr5us
    Nice job! How many holes did you have in the tubing for each of the 15 compartments of the plexiglas? Was it just one tube hole per compartment?