Install sliding driveway gates that run on a track
506,574
Published 2021-01-26
Link to website: www.grantsautomation.com.au/index.php?page=64
Email Grant: [email protected]
All Comments (21)
-
Literally the GOAT of all gate videos. This let me figure out the components I need to make my own! Thank you!
-
Fantastically well explained. This video is going to help millions of people over a very long time.
-
This was the most informative video about slide gates I’ve found! Thanks!
-
I just love this guy's voice. He's so funny, pure joy to listen plus knowledgeable! Thanks for sharing!
-
So simply explained, easy to understand. Best vdo ever. Tyvm
-
Do you have any videos explaining how to install a sliding gate with a pedestrian gate that slides outside instead of inside the wall?
-
What an amazing and super informative video 👌👌👌 Thanks for sharing 👍
-
It's full of useful information, thanks! It would be even better without (loud) music.
-
Good work
-
This is a very impressive practical lesson.
-
Thanks for sharing your knowledge. I have some questions. Can I use more than one pair of guard rollers? My gate will be little bit more than 6m and I am thing of using couple pairs of guard rollers for added security. Can you recommend some gate motors? Thanks
-
Explained very well! Just one question, does the track on the ground create a puddle of water after rain?
-
Excellent video...many thanks!
-
What a great video for anyone to understand what might at first seem complex. We have a sliding gate which was comes off its track regularly. The installer say it’s because the steel frame on one side is exposed to sun and expands more than the other side creating warping in the 8 meter wide frame. Any suggestions on how to resolve this?
-
How does a automatic sliding door with this motor will be locked. As in, In an event a sliding gate without a motor can be manually pushed and entered.. So even if the motor is fixed if we are gone will this gate be able to manually open
-
Fantastic video
-
How to increase the gate's height if the roller bearing is welded instead of fastened? I am facing a problem the gate is getting too low to get in contact with the motor. Anyway to overcome this? Layer up the track? Height adjust gear rack?
-
What is the typical installation cost?
-
Good video , but do you have any videos or suggestions on how to make a slider burglar proof.how to stop gate being lifted etc off the track etc
-
I’m trying to run electric wires to my gate for a motor installation. About 400lft . Any recommendations for the best type of wire? I have 20’ sliding gate
