SKIM KEY PROBLEM SOLVED - Dodge Jeep and Chrysler SKIM removal from PCM

112,180
101
Published 2021-01-12

All Comments (21)
  • @miekolock4060
    As a automotive locksmith this is very helpful info!! Next step for me learning to flash a the pcm!!
  • @taylorspears2636
    This fixed my jeep thank y'all so much. If anybodys skirmish ha about this it works 100% I'ma West Virginia country boy. I aint goin lie to ya
  • @mitchconner6076
    READ ALL THE INSTRUCTIONS!! Im a mechanic and the "first guy" to mess with a jeep botched the job. So this info coupled with reading ALL of the instructions helped me figure this damned thing out.
  • Went and had chip blanks ordered from Amazon, cut at Walmart. I pulled the Skim out and attached the original key in to the Skim loop with the metal shaft going into the loop. Taped it on with electrical tape and a small cable tie. Removed column cover and put skim behind it. Jeep turns over everytime with new chip keys. Tricked the skim with old key. $20 for total job. Fob works too!
  • @josh22784lori30
    On a 2007 jk when you unplug the wcm it kills power to the pcm. How do you get around this?
  • @mars188
    have a 1999 dodge caravan i looked cannot find the skim module nothing there. has a wire going to the immobilizer .
  • @Dokmaxx1
    I have a 2002 Dodge Dakota Sport I added a new computer from all Computer Resources and found that I have a SKIM problem now. Never had a problem before. I've followed the videos for the SKIM removal but there isn't a module in the steering column. Where else would it be?
  • @hyperpt4237
    HI there, i just talk to one of your sales. i need to know by deleting the skim module it will delete the P1686 code. and by replacing he pcm it will delete the 1698 code and 1687 code. and do you guys shipped to indonesia post code 10710
  • @dinopersonal7
    Grand cherokee limited gas . 2015 . Sometimes doesn’t start . Like this time . Didn’t start I had to take to service and show when past to computer scan shows this “PQ513 Skim key invalid stored “ After eraser the problem Did start but sometime after the problem comeback . And didn’t start .
  • @Matt85USA
    Just used these guys....I was super easy and I did the 2 day air. It was super fast..my jeep started right up. I got my skim delete...but now it does run rough which it didn't run rough before and the jeep only been sitting 3 months? Not sure. But these guys did what they said no bullshit
  • @FireEagleTC
    Hi, im from Perú, i need help With my Jeep WJ 4.7 2001.
  • @PavLockLocksmith
    I have a question. One immo off it will start button still works in 2012 grand cheeroke fobik key?
  • @scientist100
    Will this work on a 2005 Dodge Durango 4.7? It reads "NGC/SKREEM Status : Engine Disable Command" currently. Key programmer said that the keyfob gets programmed and the WCM is not picking up the signal from the key thus always going into engine disable mode. He says faulty WCM, I opted to have the security system removed. Let me know if it would work on a system like this. Thank you!
  • @juukeze_691dd8
    Okay, so what if I have a used Skim Module from a junkyard. Could I still be able to use that skim module from a different Dodge Durango to the one I have? Both of them are the same year, my skim module burnt out so I was told to get a new one or used one.
  • Hello I would like to know after the skim module bypass chrysler 300c what should I do with the security. Whe I open the door i have headlights and flasher on and off all the time for about 30 seconds. How can I neutralize the security ????
  • Why is there no listing on your site for a 2003 Jeep Wrangler, but there is for a 2002 and 2005? Will a 2002 PCM work on my 2003 TJ?
  • Hi, what is the postage cost to Australia ? Any Idea of turn around time ? Is the cost of having a PCM sent with my paying the bond on sending mine back the same ? ( I guess that's just a tested SKIM removed unit you send ? ) I have to just send my PCM part number and VIN ? How quickly can you get one underway ? Curious about the PCM VIN..... what is it in the car that the VIN in the PCM is reconciled with ? Is it the BCM ? Just curious.